🎯 Run Until Here and the Run Log

Test your automation up to the step you choose, and follow each step as it runs.

Two new tools make testing in the editor easier. Run Until Here runs your flow only up to a component you pick, so you can try the middle steps without sending the email at the end. And when you run the whole automation, a Run Log opens next to the editor and shows each component as it runs, so you can see which ones passed and where a run stopped.

What’s new

Run Until Here

• Right-click any component and choose Run Until Here.

• The automation runs step by step, including that component, and then stops.

• Components after it are not run. Use it to check the middle of a flow before the final steps, such as sending an email or updating a record, take real action.

Run Log

• When your automation is ready to save, the Run All button appears on the right side of the toolbar at the top of the editor.

• Click it and a Run Log opens on the right with the components listed one by one as they run.

• For every component, you see a status mark, the time it ran, and how long it took. The top of the log shows the overall status, the start time, and the total duration.

• Components inside an iterator are shown under it, with the number of iterations and how many times each inner component ran. For example, “Iterate List (6 iterations)” followed by “Send Email (SMTP) (6 runs)”.